Using The Remote Control To Operate A Vcr Or Cable Tv Converter - Toshiba 32A32 Owner's Manual

Using the remote control to operate a VCR or cable TV converter
• If you have a non-Toshiba VCR or cable TV converter, you must first program the remote control to recognize your
VCR or converter brand (see pages 13-14).
• To use your TV remote control to operate a VCR, set the TV/CABLE/VCR switch to VCR. The shaded buttons in the
picture below will then operate the VCR instead of the TV.
• To use your TV remote control to operate a cable TV converter, set the TV/CABLE/VCR switch to CABLE. The
shaded buttons shown in the picture below will then operate the converter instead of the TV.
Point the remote control at the VCR or cable TV converter
m
m
m
Channel Numbers
Press to directly access channels (as
opposed to the Channel A/V buttons).
TV/CABLE/VCR Switch --
x
Set to CABLE to control the
\
cable converter; set to VCR to
control the VCR.
TV/VCR
To view one program while
recording another, press to select
TV mode.
REC
Starts tape recording.
SLOW
In play mode, press to view a
slow-motion picture.
PAUSE
In play or record mode, press to freeze
the picture; press again to release.
POWER
RECALL MUTE
@ @
,rTV
_CABLE
_VCR
FAV CH T1
r-v-1r-r-i!
STILL SOURCE PIP
SLOW PAUSE REW
TOSHIBA
CT-90037
-- POWER
Turns the VCR (or cable TV
converter) on and off.
ENTER
Required by some VCRs and cable TV
converters to change the channel.
-- CHANNEL A/V
• selects the next higher channel,
and • selects the next lower channel.
-- STOP
Stops the tape.
-- PLAY
Begins tape playback.
--
FF
Fast-forwards the tape.
In play mode, press to view the picture
moving rapidly forward.
REW
Rewinds the tape.
In play mode, press to view the
picture moving rapidly backward.
12