Programming The Remote Control To Operate A Non-Toshiba Vcr Or Cable Tv Converter - Toshiba 32A32 Owner's Manual

Programming the remote control to operate a non-Toshiba VCR
or cable TV converter
Your Toshiba TV remote control is preprogrammed to operate Toshiba brand VCRs and cable TV converters. To
program your TV remote control to operate a non-Toshiba VCR or a cable TV converter, follow these steps:
PowER
@
_TV
_CABLE
_VCR
FAV CH TV/VlDEO
r-v-i r-x-i r-_--i
REC TVNCR STOP PLAY
1-_ IZ3 l-i] 1-_
STILL SOURCE PiP
SLOW PAUSE REW
VPlP CHA LOCATE SWAP
TOSHIBA
CT-90037
RECALL
-- POWER
1
2
-- Channel
Numbers 3
4
In the code table on page 14, find the code for your brand of VCR or
cable TV converter.
If more than one code is listed, try each one separately until you find
one that works.
Set the TV/CABLE/VCR switch to VCR (for a VCR), or CABLE (for
a cable TV converter).
While holding down RECALL, press the Channel Number buttons
to enter the 3-digit code for your brand of VCR or converter.
To test the code, turn the VCR or converter on, point the remote
control at it, and press POWER.
-If the correct code was entered, the VCR or converter will turn off.
-If the VCR or converter does not respond, repeat steps 1-4 using
another code.
-If the VCR or converter does not respond to a different code,
you will need to use the remote control that came with your VCR or
converter.
5
Set the TV/CABLE/VCR
switch to TV to control the TV.
For future reference, write down the code(s) you used:
VCR Code:
Cable TV Converter Code:
Note:
You must reprogram the remote control every time the batteries are changed.
Some newer VCRsrespond to either of two codes. These VCRshave a switch
labeled "VCR1/VCR2." If your VCR has this kind of switch and does not respond
to the codes for your VCRbrand, set the switch to the other position C'VCR1" or
"VCR2") and reprogram the remote control
13