Table of Contents
Advertisement
Using the remote control
Preparing the remote control for use
With the remote control, you can operate your TV, most VCR
models, and cable TV converters together, even if they are different
brands. If you will be using your TV with a Toshiba VCR, your
remote control is already programmed and ready to use. If you own
different brands of VCRs and/or converters, you first have to program
your remote control. (See “Programming the remote control for use
with a VCR or a cable TV converter” on page 8.)
Installing the remote control batteries
To install the batteries:
1. Slide the battery cover off of the back of the remote control.
2. Install two “AA” size batteries. Match the + and - signs on the
batteries to the signs on the battery compartment.
3. Slide the battery cover back on to the remote control until the
lock snaps.
Using the remote control with a VCR or a cable
TV converter
To control a Toshiba VCR:
Set the TV/CABLE/VCR switch to the VCR position. The
buttons shown to the right will then control the VCR. The
rest of the buttons will operate the TV as usual.
To control a cable TV converter:
Program the remote control to recognize the brand of your
converter (see “Programming the remote control for use with a
VCR or cable TV converter,” page 8). The shaded buttons shown
on the right will control the cable TV converter.
Set the TV/CABLE/VCR switch to the CABLE position.
Note:
This remote control’s functions may or may
not operate your VCR or cable TV converter.
Refer to the owner’s manuals supplied with
the equipment to see which features are
available. In addition, the original controllers
may have features not available on this
remote control. If you would like to continue
to use these features, you may want to use
the original remote control.
Caution:
• Dispose of your batteries in a designated
disposal area. Do not throw your batteries
into a fire.
• Do not mix battery types or combine used
batteries with new ones.
• Remove dead batteries immediately to
prevent battery acid from leaking into the
battery compartment.
• If you do not intend to use the remote
control for a long time, remove the
batteries.
POWER
RECALL
MUTE
POWER
2
1
3
4
5
6
Channel
9
8
7
Number
CH RTN
Enter
100
0
ENT
Channel
CH
MENU/
VOL
VOL
ENTER
CH
TV/Cable/VCR
TV
CABLE
VCR
EXIT
TV/VCR
FAV CH
TV/VIDEO
Play
REC
TV/VCR STOP
PLAY
Stop
STILL SOURCE PIP
Record
SLOW PAUSE REW
FF
Fast Forward
PIP CH
LOCATE SWAP
Rewind
Pause
Slow
Note:
Some cable/TV converters may require the
ENT key to be pressed after pressing channel
numbers. (i.e. 0 – 2 – ENT)
Page 7
Advertisement
Table of Contents
