Advertisement
ii{ii::!_!!i!ii!!
!if{!ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! ii!!!!! iii!!i ¸
Open the battery compartment
cover in the direction of the
arrow.
Install two "AAA" batteries
_
Replace the compartment
(supplied),
paying
attention
to the
,_
cover.
polarity
diagram
in the battery
compartment.
&
r,
Battery precautions
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Re-
versed batteries may cause damage to the device. To avoid a potential short circuit, insert the "-" end first.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer's directions.)
• Press POWER (Vdo) to turn the DVDNCR on or off.
• Select your desired operating mode (DVD or VCR) using DVDNCR.
(DVD or VCR indicator on the front panel will show you which mode is selected.)
• Press OH ^ or ON v to move through the channels one channel at a time.
• The CH ^IV
(A IV') and SET +1- (,
/ ,) are also used to navigate on-screen menu system.
• You can directly access specific channels using Number buttons.
• Each press of DVDNGR on the remote control, switches the screen between the VCR screen (VCR mode) and the
DVD screen (DVD mode).
Operation
• Aim the remote control at the remote sensor and press control buttons to
operate.
• Operate the remote control within 30° angle on either side of the remote
sensor, up to a distance of Approx. 7 meters.
J
1
'
/i\
_Approx.
i meters
U
'_
131
Advertisement
