Advertisement
tting
the video channel
When a TV is connected with the 75 ohm coaxial cable only.
To view playback of a recorded tape or DVD disc, or to watch a
program selected by the VCR's channel selector, the TV must be set to
channel 3 or4 (video channel).
TV/VCR
12
Press POWER to turn on the DVD/VCR.
Press DVDNCR
to select the VCR mode.
DVD/VCR
The VCR indicator on the
Q
front panel will light.
Set the 3/4 Channel selector switch on the rear
panel to CH 3 or 4.
3[]4
CH
Turn ON the TV and set to CH 3 or 4 to corre-
spond with the channel selected in step 3.
Press TVNCR
to select the VCR position.
TV/VCR
The VCR indicator will
appear in the display
window.
select any channel to receive a TV station in your area,
The channel number will appear on the screen for
about 4 seconds,
• For a push-button
TV tuner
If CH 3 or 4 corresponding
to the video channel cannot
be tuned on your TV, proceed as follows: set the VCR
3/4 channel selector and the TV to CH 3 or 4, play
back a prerecorded tape and tune the TV to receive a
sharp color picture from the video cassette recorder.
Refer to your TV owner's manual for details.
Notes:
• if the unit does not operate properly, or No key op-
eration (by the unit and/or the remote control): Static
electricity, etc., may affect the player's operation. Discon-
nect the AC power cord once, then connect it again.
• When you turn on the DVD/VCR which has disc inside,
DVD playback will start automatically.
ff the operating n_ode was VCR, when you turned on the
DVD/VCR which has disc inside, it will play back auto-
matically and stop after about 5 minutes.
• During the DVD playback
if you change the operating
mode from DVD to VCR, the DVD will continue to play
back the disc and stop after about 5 minutes.
122
Advertisement
