Sony HANDYCAM DCR-TRV330 Operating Instructions Manual page 141

Maintenance information and precautions
Your camcorder is supplied with a nranganese-lithiunr battery installed so as to retain
the date and time, etc., regardless of the setting of the POWER switch. The manganese-
lithium battery is always charged as long as you are using your canrcorder. The battery,
however, will get discharged gradually if you do not use your camcorder. It will be
completely discharged in about half a year if you do not use your camcorder at all. Even
if the manganese-lithium battery is not charged, it will not affect the camcorder
operation. To retain the date and time, etc., charge the battery if the battery is
discharged.
Charging the manganese-lithium battery:
• Conn_,ct your camcorder to a wall outlet using the AC pow_,r adaptor supplied with
your camcorder, and leave your camcorder with the POWER switch turned off for
more than 24 hours.
• Or install the fully charged battery pack in your camcorder, and leave your camcorder
with the POWER switch turned off for more than 24 hours.
Camcorder operation
• Operate your camcordc, r on 7.2 V (battery pack) or 8.4 V (AC power adaptor).
• For DC or AC operation, use the accessories recommended in this operating
instructions. >
D-
• If any solid object or liquid get inside the casing, unplug your camcorder and have it __
checked by a Sony dealer before operating it any further, o
• Axoid rough handling or mechanical shock. Be particularly careful of tire lens.
• Keep the POWER switch set to OFF (CHG) when you are not using your camcorder.
• Do not wrap your camcorder with a towel, for example, and operate it. Doing so =
might heat to build up inside.
cause
• Keep your camcorder away from strong magnetic fields or mechanical x ibration.
Noise may appear on tire image.
• Do not touch the LCD screen with your fingers or a sharp-pointed object.
• If your camcorder is used in a cold place, a residual image may appear on tire screen.
This is not a malfunction.
• While using your camcorder, the back of the LCD screen may heat up. This is not a
malfunction.
On handling tapes
• Do not insert anything into the small lrolc,s on the rear of the cassette. These holc_s arc_
used to sense the type and thickness of the tape and if the recording tab is in or out.
• Do not open the tape protect cover or touch the tape.
Camcorder care
• Remove the tape, and periodically turn on the power, operate the CAMERA and VCR
sections and play back a tape for about 3 minutes when your camcorder is not to be
used for a long time.
• Clean the lens with a soft brush to remove dust. If there are fingerprints on the lens,
remove them with a soft cloth.
• Clean the camcorder body with a dry soft cloth, or a soft cloth lightly moistened with
a mild detergent solution. Do not use any type of solvent which may damage the
finish.
• Do not let sand get into your canrcorder. When you use your camcorder on a sandy
beach or in a dusty place, protect it from the sand or dust. Sand or dust may cause
your camcorder to malfunction, and sometimes this malfunction cannot be repaired.
141