13.
Figures 22 & 24
Figure 24.
14.
15.
16.
Figure 25.
Figure 25
Note: Orient the two assemblies so that the
large, round intake port of the intake barrel
is NOT directly underneath the rectangular
outlet port of the blower housing. The outlet
port will connect to the canister filters and will
not allow room for attachment of the intake
ducting to the intake port.
17.
Figure 26
Figure 26.
Tip: When installing the two bolts above the
intake port of the intake barrel, use duct tape
on the bottom of your wrench. This will hold
the bolts in the wrench while inserting them in
place (see Figure 27
Figure 27.