Maytag MER5875RAF - Frost 30 Inch Electric Range Use And Care Manual page 9

@
Control Panel
A B C D E G
2 3
4 5 6 0
8 9
H [ J K LM N 0
The control parle[ is designed for ease hl programmhg. The dispiaywhdow on the control shows time of day',timer and oven function&
Control pane[ shown includes Convect and other mode[ specific features. @tyiing may vary' depending on mode[.]
A
B
D
Ei!
F
G
N
K
L
lVl
N
Bake
Broil
Clean
Convect Roast
Delay
Number Pads
Autoset
Keep Warm
Convect Bake
Cook & Hold
Favorite
Timer
CHock
Oven Light
CANCEL
Use for baking and roasting.
Use for broiling and top browning.
Use to set self-clean cycle.
Use for convection roasting.
Programs the oven to start baking at
a later time.
Use to set time and temperature.
Use to quickly set temperatures.
Use to keep cooked food warm in oven.
Use for convection baking.
Bakes for a preset time, then holds
food warm for 1 hour.
Use to set and save a specific Cook &
Hold procedure.
Sets Timer.
Use to set time of day clock.
Use to turn the oven light on or off.
Cancels all operations except Timer
and Clock.
Using the Touchpads
Press the desired pad.
Press the number pads to enter time or temperature.
Press the Autoset 0 pad to enter temperature.
° A beep will sound when any pad is touched.
° A double beep will sound if a programming error occurs.
8
Note: Four seconds after pressing the number pads or
the Autoset 0 pad, the time or temperature will automati-
cally be entered. [f more than 30 seconds elapse between
touching a function pad and the number pads or the
Autoset 0 pad, tile function wii[ be canceled and tile
display will return to the previous display.
The clock can be set to display time in a 12-hour or 2a-hour
format. The clock is set at the factory for the 12-hour format.
To change the clock to
24-hour format:
1. Press and hold the CANCEL and
Favorite pads for three seconds.
° 12 Hr flashes in the display.
2. Press the Autoset 0 pad to select 24
Hr; press again to select 12 Hr. A
kJ
3. Set the time of day following the directions
Autoset
in the To set the Clock section.
To set the Clock:
1. Press the Clock pad.
° The time of day flashes in the display.
2. Press the appropriate number pads to set the time of day.
, Colon flashes in the display.
3. Press the Clock pad again or wait four seconds.
° The colon wiil remain on.
When electrical power is supplied or after a power
interruption, the last clock time before power was interrupted
wiii flash, cont.