Messages And Error Codes; User Attendance Messages; Paper Jam Error Codes (200-Series) - Lexmark E260dn Service Manual

4513-220, -230

Messages and error codes

Note: The following message and error codes will be visible only in the print event log in the diagnostic
mode for E260d and E260dn. See
The printer operator panel displays light patterns describing the current state of the printer and indicates
possible printer problems that must be resolved. This topic provides a list of all printer messages and explains
what they mean.

User attendance messages

Cartridge error codes
Error
31.xx
32.xx
33.xx

Paper jam error codes (200-series)

Repeating jams or jam messages can be caused by any of the following:
•
Faulty/contaminated pick solenoids or worn cams of the solenoids.
•
Faulty/contaminated flags or springs.
•
Debris in the paper path.
•
Media not of the specified length.
Paper jam error codes (200-series)
Error Description
200.00 Paper jam around input sensor.
200.01 Classic input jam. The media is too long over the input sensor. Possible causes include multi-sheet feed, tray
size sensing problem, and media slippage.
200.02 The main input sensor never became uncovered from the sheet ahead.
200.03 The video never started on the page at the input sensor within two inches after hitting the input sensor
200.04 The media at the input sensor before interrupt occurred–not enough time elapsed since the printhead started
to expect the printhead mirror motor lock. Possible causes include bouncy sensor or exceptionally fast pick–
perhaps due to media pre-staged in the source tray.
200.06 Imaged page not expected page (bouncy passthru sensor)
200.08 Media reached the input sensor before the EP was ready
200.09 Transfer servo never started
200.11 Mirror motor fell out of lock condition after paper at input sensor
200.12 Media detected at manual feeder sensor when not expected. Possible causes include user insert of media
when motor is running or pre-staged media in the tray.
200.13 The input sensor is covered when the media is not expected (media in machine during warm-up)
2-36
Lexmark™ E260d, E260dn
"Diagnostics mode selections" on page
Description
Defective cartridge
Unsupported cartridge
Invalid refill
3-8.