4513-220, -230
Overview of the operator panel
Power-On Self Test (POST) sequence
When the printer is turned on, it performs a POST. Check for correct POST functioning of the base printer by
observing the following process:
1.
All operator panel lights on momentarily
2.
Lights then flash on and off sequentially.
3.
After the lights quit flashing, the
seconds, depending on the initial temperature of the fuser) and then stays on.
4.
If there is a problem in the printer such as a paper jam, then the panel lights indicate the problem. See
"Common primary light patterns" on page 2-4
5.
The printer cycles down into standby mode, and
2-2
Lexmark™ E260d, E260dn
Toner
Paper
light
jam
light
Load
paper
Error
light
light
light flashes until the fuser comes up to temperature (5-20 additional
Cancel
button
Ready
Continue
light
button
for more information.
lights solid.