Chapter 2. Setup And Installation; Unpacking And Elevating The Artist Control - Avid Technology Artist Control User Manual

Chapter 2: Setup and Installation

Unpacking and Elevating the Artist Control

Unpack Artist Control, its power adapter, AC power cord, Installer disc, Ethernet crossover cable, and riser brackets.
Artist Control can be elevated or angled using small foldout legs on the bottom of the unit or elevated and angled by attaching
the larger riser brackets. Since either method requires turning Artist Control over, it is easier to do this before attaching any cables.
Turn it over and place it on a soft surface.
Pull out all four of the small foldout legs to moderately elevate the unit; pull out only the back two to angle the unit towards you.
Pull out the metal clips from the same area as the legs and move them until they snap into the legs.
Two larger, detached riser brackets elevate and angle the unit more than the foldout legs. Use moderate force to snap them into
the bottom panel as shown.
Chapter 2: Setup and Installation 5