Avid Technology Artist Control User Manual page 13

Plug the other end of the Ethernet crossover cable into an open Ethernet jack on your computer, router, or Ethernet switch.
9
• Note that connecting directly to the computer may require removing your Internet cable. If you have a Mac with two Ether-
net ports, use Ethernet 1, rather than Ethernet 2.
Artist Control connected directly to computer
• An Ethernet router or switch is required to connect additional Artist Mix or other Artist Series unit such as an Artist Trans-
port, or to connect units to a local area network.
SOLO ON SOLO ON SOLO ON SOLO ON SOLO ON SOLO ON SOLO ON SOLO ON
Artist Control and one Artist Mix connected using a router
Turn on your router (if applicable), then turn on your computer and wait until it finishes starting up.
10
Press and release the POWER switch on Artist Control. Do the following, as appropriate for your operating system:
11
Mac Wait up to 60 seconds. A lit EuControl icon in the menu bar indicates correct installation.
EuControl icon on Mac
Windows Wait up to 60 seconds. A lit EuControl icon appears in the System tray (or, in Hidden Icons if your system is not con-
figured to show all icons in the System tray).
EuControl icon on Windows
Chapter 2: Setup and Installation 9