Memory Specifications; Fibre Channel Port Specifications; Serial Port Specifications - Brocade Communications Systems Brocade 6520 Hardware Reference Manual

Memory specifications

The Brocade 6520 has three primary types of memory devices: boot flash, compact flash, and
main memory. The size of each is listed in
TABLE 13
Memory type
Boot flash
Compact flash
Main memory (DDR2 SODIMM)

Fibre Channel port specifications

The Fibre Channel ports in the Brocade 6520 are compatible with SWL, LWL, and ELWL SFP+ (for
16 Gbps performance) transceivers. The strength of the signal is determined by the type of
transceiver in use.
The ports meet all required safety standards. For more information about these standards, refer to
"Regulatory compliance"
The ports are capable of operating at 2, 4, 8, or 16 Gbps depending on SFP+ transceiver models
and are able to autonegotiate to the maximum link speed.
The first eight ports on the switch can be configured to run at 10 Gbps with the appropriate license
and transceivers.

Serial port specifications

The serial port is located on the port side of the switch. The Brocade 6520 uses an RJ45 connector
for the serial port. An RJ45-to-RS-232 adapter is also provided with the switch.
NOTE
To protect the serial port from damage, keep the cover on the port when not in use.
The serial port can be used to connect to a workstation to configure the switch IP address before
connecting the switch to a fabric or IP network. The serial port's parameters are fixed at 9600
baud, 8 data bits, and no parity, with flow control set to None.
Table 14
TABLE 14
PIN
1
2
3
4
5
Brocade 6520 Hardware Reference Manual
53-1002705-01
Brocade 6520 memory specifications
Amount
4 MB
2 GB
2 GB, 400 MHz, 72-bit bus
on page 42.
lists the serial cable pinouts.
Serial cable pinouts
Signal
Not supported
Not supported
UART1_TXD
GND
GND
Table 13.
Description
N/A
N/A
Transmit data
Logic ground
Logic ground

Memory specifications

A
41