Table of Contents
Advertisement
IEEE 802.1s
IEEE 802.1w
IEEE 802.3ad
IEEE 802.3ae
IEEE 802.1Q
IEEE 802.1p
IEEE 802.1v
IEEE 802.1AB
IEEE 802.3x
The following draft versions of the Converged Enhanced Ethernet (CEE) and Fibre Channel over Ethernet (FCoE)
Standards are also supported on the Brocade 8000 and FCOE10-24 blade:
IEEE 802.1Qbb
IEEE 802.1Qaz
IEEE 802.1
FC-BB-5
Technical Support
Contact your switch supplier for hardware, firmware, and software support, including product repairs and part
ordering. To expedite your call, have the following information immediately available:
1. General Information
Technical Support contract number, if applicable
Switch model
Switch operating system version
Error numbers and messages received
supportSave command output and associated files
For dual CP platforms running FOS v6.2 and above, the supportsave command gathers
o
information from both CPs and any AP blades installed in the chassis
Detailed description of the problem, including the switch or fabric behavior immediately following
the problem, and specific questions
Description of any troubleshooting steps already performed and the results
Serial console and Telnet session logs
Syslog message logs
2. Switch Serial Number
The switch serial number is provided on the serial number label, examples of which are shown here:
FT00X0054E9
The serial number label is located as follows:
Fabric OS v7.0.1 Release Notes v1.0
Multiple Spanning Tree
Rapid reconfiguration of Spanning Tree Protocol
Link Aggregation with LACP
10G Ethernet
VLAN Tagging
Class of Service Prioritization and Tagging
VLAN Classification by Protocol and Port
Link Layer Discovery Protocol (LLDP)
Flow Control (Pause Frames)
Priority-based Flow Control
Enhanced Transmission Selection
DCB Capability Exchange Protocol (Proposed under the DCB Task Group of IEEE
802.1 Working Group)
FCoE (Rev 2.0)
Page 10 of 67
Advertisement
Table of Contents
