Deny (Standard Acls) - Brocade Communications Systems Brocade 6505 Command Reference Manual

2

deny (standard ACLs)

deny (standard ACLs)
Configures a MAC address rule to drop traffic based on the source MAC address.
Synopsis deny {MAC_ACL | any} [count]
no deny {MAC_ACL | any}
Operands MAC_ACL
any
count
Defaults By default, no MAC ACLs are configured.
Command Feature Access Control List configuration mode
Modes
Description Use this command to configure rules to match and to drop traffic based on the source MAC
address. You can also enable counters for a specific rule. There are 255 ACL counters supported
per port group. Use the no deny command to remove a rule from the MAC ACL.
Usage None
Guidelines
Examples To create a rule in a standard MAC ACL to drop traffic from the source MAC address
0022.3333.4444 and to enable the counting of packets:
To delete a rule from a standard MAC ACL:
See Also mac access-list
44
Specifies the source host MAC address for which to set deny conditions. Use
the format HHHH.HHHH.HHHH.
Specifies any source MAC address.
Enables counting of the packets matching the rule.
switch(conf-macl-std)#deny 0022.3333.4444 count
switch(conf-macl-std)#no deny 0022.3333.4444
standard, permit (standard ACLs)
Converged Enhanced Ethernet Command Reference
53-1002508-01