Mode - Brocade Communications Systems Brocade 6505 Command Reference Manual

2

mode

mode
Sets the LLDP mode on the switch.
Synopsis mode tx | rx
no mode
Operands tx
rx
Defaults Both transmit and receive modes are enabled.
Command Protocol LLDP configuration mode
Modes
Description Use this command to set the LLDP mode on the switch. Use the no mode command to return to the
default setting.
Usage None
Guidelines
Examples To enable only the transmit mode:
See Also show lldp
108
Specifies to enable only the transmit mode.
Specifies to enable only the receive mode.
switch(conf-lldp)#mode tx
Converged Enhanced Ethernet Command Reference
53-1002508-01