Table of Contents
Advertisement
Touchmonitor Connections
1. Connect the mini-B plug of the provided USB Y cable to the mini-USB port on the monitor,
and connect the "Data Cable" connector of the provided USB Y cable into one of your
computer's USB ports.
NOTE: Some computers may not provide enough power to the monitor
from one USB port. If so, connect the "Aux Power Cable" USB connector
on the Y end of the cable into another USB port on your computer.
2. The touchmonitor ships in an ON state: video should be displayed on your monitor once the
DisplayLink™ driver is installed on your computer.
Installing the DisplayLink Software Drivers
The DisplayLink technology enables video-over-USB. It allows your monitor to use one USB
cable for power, video and touch.
NOTE: This monitor can not function as Primary display during boot-up. An
additional display must be used to install the DisplayLink driver.
The drivers for the Windows 7, XP 32-bit (SP2, SP3), Vista 32-bit (SP1), and Vista 64-bit (SP1)
operating systems are provided with your touchmonitor on a CD.
Look in the USB Monitor folder in the Elo TouchTools CD for detailed driver manual.
User Manual – 0700L
SW601504 Rev B
-
Page 6 of 20
Advertisement
Table of Contents
