Table of Contents
Advertisement
PROGRA/v_iv_ING-THE
REMOTE
TO CONTROl.
A LASERDISC
PLAYER
'The remote
may need to be programmed
foryour
equipment.
This remote may not operate
all models of the brands that
are shown below.
Use the codes at right or on the sheet
packecl with your remote.
1.
Turnonthe
laserdisc player.
2.
Look up your brand and its code number(s) on code list
at right.
3.
Press and hold the DVD-VCR button on the remote.
4.
Enter the two-digit
code from the code list.
5.
Release the DVD°VCR button and press POWER or another
button to see if the laserdisc player responds to the
remote commands.
6.
Repeat these steps using the next code listed for your brand,
until the laserdisc player responds to the remote commands.
PROGRAMMING
TH E REMOTE
TO CONTROL
AN
RCA AUDIO
DEVICE:
Your remote controls
only RCA audio equipment
such as an
audio receiver
or amplifier--it
does not control
other
brands
of audio equipment.
Also, the remote
may need to be
programmed
for your equipment.
This remote
may not
operate
all models of the brands that are Shown at right.
Use
the codes below
or on the sheet packed in with your remote.
1.
Turn on the component
to be programmed.
2.
Look up your brand and its code number(s)
on the code
list at right.
3.
Press and hold the AUDIO button.
.
5.
Enter the two-digit
code from the code !ist.
Release the AUDIO button
and press POWER or CHAN UP
or DOWN to see if the audio device responds to the
remote
commands.
6.
Repeat these steps using the next code listed for your brand
until the audio device responds to the remote
commands.
I
aserdisc
Player
Codes 1
ProScan........................ ;.......:.......33
RCA
........ . ................. 33
Audio
Codes
RCAJ Dimensia
AM/FM .........................................
03
CD ................................................
07
Tape ..............................................
06
Phono ...........................................
05
Aux ...............................................
04
26
Advertisement
Table of Contents
