Programming The Remote; To Control A Dvd Player Or Laserdisc Player; To Control An Rca Audio Device - RCA P50830 User Manual

PROGRAMMING TH E REMOTE TO CONTROL
A DVD PLAYER OR LASERDISC PLAYER
The remote's DVD.VCR2 button is preprogrammed to control the
primary functions of an RCA, GE, or ProScan DVD player. If you
would like this button to control a device other than a DVD
player, you may program the remote to control a laserdisc player
or VCR. To program the DVD.VCR2 button to control a device,
use the DVD player or laserdisc player codes at the right or the
VCR codes on the previous page.
1. Turn on the DVD player, laserdisc player or VCR.
2. Look up your brand and its code number(s)on the code lists.
3. Press and hold the DVDoVCR2 button on the remote.
.
5.
Enter the two-digit code from the code list.
Release the DVD.VCR2 button and press POWER or another
button to see if the device,responds to the remote
commands.
6. Repeat these steps using the next code listed for your brand,
until the device responds to the remote commands.
I DVD Player Codes 1
GE ............................................... 78
ProS<:an 78
RCA ............................................. 78
I Laserdisc Player Codes 1
Pioneer .................................. 33,37
ProScan ................................. 33,37
RCA ........................................ 33,37
PROGRAMMING THE REMOTE TO CONTROL
AN RCA AUDIO DEVICE:
Your remote controls only RCA audio equipment such as an
audio receiver or amplifier--it does not control other brands of
audio equipment. Also, the remote may need to be programmed
for your equipment. This remote may not operate all models of
the brands that are shown at right. Use the codes below or on
the sheet packed in with your remote.
1. Turn on the component to be programmed.
2. Look up your brand and its code number(s) on the code list.
3. Press and hold the AUDIO button.
4. Enter the two-digit code from the code list.
5. Release the AUDIO button and press POWER or CH ^
(channel up) or CH v (channel down) to see if the audio
device responds to the remote commands.
6. Repeat these steps using the next code listed for your brand
until the audio device responds to the remote commands.
r
Audio Codes
RCA/Dimensia
AM/FM ....................................... 03
CD ............................................... 07
Tape ........................... • ................. 06
Phono ......................................... 05
Aux ............................................. 04
32