Table of Contents
Advertisement
PROGRAMMI
NG TH E REMOTE
TO CONTROL
A LASERDISC
PLAYER
'The remote
may need to be programmed
for your equipment.
'This remote may not operate all models of the brands that
are shown below.
Use the codes at right or on the sheet
packed with your remote.
1.
Turn on the laserdisc player.
2.
Look up your brand and its code number(s) on code list
at right.
3.
Press and hold the VCR2-LD button on the remote.
4.
Enter the two-digit
code from the code list.
5.
Release the VCR2.LD button and press POWER or another
button to see if the laserdisc player responds to the
remote commands.
6.
Repeat these steps using the next code listed for your brand,
until the laserdisc player responds to the remote commands.
I
Laserdisc
Player
Codes
/
ProScan........................................
33
RCA.....
..................................
i...... ssl
J
PROG RAMMI
NG TH E REMOTE
TO CONTROL•
AN
RCA AUDIO
DEVICE:
Your remote controls only RCA audio equipment
such as an
audio
receiver or amplifier.
It does not control
other
brands
of audio equipment.
The remote may need to be programmed
for your RCA equipment.
This remote
may not operate
all
models of the brands that are shown at right.
Use the codes
at right
or on the sheet packed in with your remote.
1.
Turn on the component
to be programmed.
2.
Look up your brand and its code number(s)
on the code
list at right.
Press and hold the AUDIO button.
.
4.
5.
.
Enter the two-digit
code from the code list.
Release the AUDIO button
and press POWER orCHAN
UP
or DOWN to see if the audiodevice
responds to:the
remote commands.
Repeat these steps using the next code listed for your brand
until
the audio device responds to the remote commands.
Audio
Codes
RCA/Dimensia
AM/FM Receiver ........................ 03
CD ................................................
07
Tape ..............................................
06
Phono...........................................
05
Aux ...............................................
04
26
.o
Advertisement
Table of Contents
