Table of Contents
Advertisement
U
S I N G
Programming your Universal Remote
The universal remote can be programmed to control most brands of remote controllable
VCRs, satellite receivers, Laserdisc players and cable boxes. If you have an RCA, GE, or
PROSCAN component, you probably don't need to program it at all.
Testing the Remote
To determine whether the universal remote needs to be programmed, turn a device on, such
as a VCR, point the remote at the VCR, and press the VCR1 button. Then press POWER or
CHAN L (channel up) or CHAN M (channel down) to see if the VCR responds to the
remote commands. If not, the remote needs to be programmed.
Programming the Remote to Control a VCR, Laserdisc player,
Satellite Receiver or Cable Box
Follow these steps to program your universal remote to control a VCR, Laserdisc player,
Satellite Receiver or Cable Box:
1. Turn on the component to be programmed.
2. Look up the brand and code number(s) for the component on the code list on the last
3. Press and hold the button on the remote you want to program.
4. Enter the code from the code list.
5. Release button, and then press POWER to see if the component responds to the
6. If you get no response, repeat these steps using the next code listed for your brand,
3.4
C
T
: U
HAPTER
HREE
SING
T
R
H E
E M O T E
page of this section, Using the Remote.
remote commands. If it doesn't, try pressing the component button and then POWER
again.
until the component responds to the remote commands.
T
R
HE
EMOTE
Advertisement
Table of Contents
