Electrolux EON6001S User Information page 10

This hob is made to be installed above a built-in oven;
The supply wires must be placed in such a way as to
ensure they do not come into contact with the hot
parts of the oven in order to avoid overheating.
Suitable air inlets (E) should be foreseen only if there are
not enough air circulation below the oven, to allow for
the proper ventilation around the piece of furniture,
as illustrates; For the correct working of the hob,
it is vital that the minimum distances (C and D) shown
in the picture be respected. All surfaces adjacent to
the cabinet and the back panel should be made of
materials resistant to a temperature of 90°C
C: 85mm
D: 50mm
E: 30x40mm
To fix the cooktop in the housing, proceed as follows:
1) Position the special gasket supplied [C] along the outer perimeter of the
worktop, so that the ends of the gasket meet exactly without overlapping.
2) Position the cooktop into the worktop, taking care to ensure it is placed exactly in the centre.
3) Fix the cooktop to the worktop using the special brackets supplied [A], as shown.
A correct installation of the sealing gasket ensures complete protection against infiltration of liquids
Fig. 4
Fig. 3
6
D