D-Link DES-6300 User Manual page 149

Modular L3 Ethernet Switch User's Guide
3. Click . The entry is deleted.
4. Click . When the Status field displays "Finished!", the fields are confirmed as modified.
IP Redundancy
To display the IP Redundancy Table:
♦ Select Router > IP > IP Redundancy. The IP Redundancy Table opens:
Figure 6- 120. IP Redundancy Table window
The IP Redundancy Table displays the following parameters:
♦ Interface IP Address – The IP address on which the redundancy feature is running.
♦ Main Router Address – The router IP address that the device is backing up.
♦ Operating Status – The entry status:
◊
Active – The backup router is active on this interface.
◊
Inactive – The backup router is not active on this interface.
♦ Poll Interval – This router-polling interval, in seconds. If the interval is 0 then the router is
not polled.
♦ Time Out – The interval in seconds during which the router must signal. If the router does
not signal within this interval it is considered non-operational. If Time Out is equal to 0, the
device ignores the row.
To add an IP Redundancy Table entry:
1. Display the IP Redundancy Table.
2. Click . The IP Redundancy Table Insert window opens:
149