Dell Broadcom NetXtreme Family of Adapters User Manual page 48

NetWare Driver Software: Broadcom NetXtreme II Network Adapter User Guide
operating system. This is a common feature supported in NetWare. The poll mode may increase driver performance in some
environments.
Poll = 1 (on)
Poll = 0 (off)
The default value is 0 (Poll mode is off).
Wirespeed=
This feature provides adapter link and data integrity even if the adapter is attached to a questionable cable and/or switch. For
example, an adapter that is trying to connect at 1000 Mbit/s on a Category 3 cable ordinarily would not link. With Wirespeed
set to 1, the link is made at 100 Mbit/s.
Wirespeed = 1 (on)
Wirespeed = 0 (off)
The default value is 1 (Wirespeed is on).
Model=
This keyword allows the addition of a subsystem ID of a specific NIC so that the driver loads only on the first NIC found with
a matching subsystem ID. For example, MODEl= 0x14e4. The default value is 0
MagicP=
When MagicP=1, the driver enables the adapter to wake up the system when a Magic Packet™ frame is received after the
system is shut down. MagicP=0 is the default setting with the adapter having no wake-up ability.
MagicP = 1 (on)
MagicP = 0 (off)
The default value is 0 (No wake-up capability).
Fiber=
The driver has support for the 1000FD fiber adapter. The fiber auto-negotiates link with a fiber switch even though it only
supports 1000FD. In some cases, the user may want to force the adapter to 1000FD.
AUTO (default)
FORCE
NOTE: If you modify any of the adapter properties, you must reboot the system before the changes take effect. If you
make changes and do not reboot, you may experience problems.
A valid Autoexec.ncf file is shown below. One set of load and bind commands (in bold) is added for each frame type the
adapter is configured to support.
SET Daylight Savings Time Offset = 1:00:00
SET Start Of Daylight Savings Time = (MARCH SUNDAY LAST 2:00:00 AM)
SET End Of Daylight Savings Time = (OCTOBER SUNDAY LAST 2:00:00 AM)
SET Time Zone = TPST8TPDT
# Note: The Time zone information mentioned above
# should always precede the SERVER name.
# WARNING!!
FILE SERVER NAME DL760
# WARNING!!
# If you change the name of this server, you must update
# the server name in all the licenses that are assigned
# to it using iManager.
SERVERID 487B10D
LOAD ODINEB.NLM
LOAD IPXRTR
LOAD IPXRTRNM
LOAD TCPIP
LOAD BX2 SLOT=2 FRAME=Ethernet_802.2 NAME=BX2_1_E82
BIND IPX BX2_1_E82 NET=FAFD3D25
LOAD BX2 SLOT=2 FRAME=Ethernet_802.3 NAME=BX2_1_E83
BIND IPX BX2_1_E83 NET=5A2D8D6D
LOAD BX2 SLOT=2 FRAME=Ethernet_SNAP NAME=BX2_1_ESP
BIND IPX BX2_1_ESP NET=477A35BD
file:///T|/htdocs/NETWORK/BroadCom/71921/NetXtremeII/en/netware.htm[9/26/2012 3:28:49 PM]