Diagnostic Test Descriptions - Dell Broadcom NetXtreme Family of Adapters User Manual

User Diagnostics: Broadcom NetXtreme II Network Adapter User Guide
uediag -fib <ib_image> Specifies the bin file for iSCSI boot.
uediag -fibc
uediag -fibc2
uediag -fibp
uediag -fipmi
<ipmi_image>
uediag -fmba
<mba_image>
uediag -fnvm
<raw_image>
uediag -fump
<ump_image>
uediag -help
uediag -I <iteration#> Specifies the number of iterations to run on the selected tests.
uediag -idmatch
uediag -log <logfile>
uediag -mba <1/0>
uediag -mbap <n>
uediag -mbav <1/0>
uediag -mbavval <n>
uediag -mfw <1/0>
uediag -t
<groups/tests>
uediag -T
<groups/tests>
uediag -ver
uediag -wol <1/0>

Diagnostic Test Descriptions

The diagnostic tests are divided into four groups: Basic Functional Tests (Group A), Memory Tests (Group B), Block Tests
(Group C), and Ethernet Traffic Tests (Group D). The diagnostic tests are listed and described in
Table 3: Diagnostic Tests
Test
Number Name
Group A: Basic Functional Tests
A1 Register
PCI
A2
Configuration
file:///T|/htdocs/NETWORK/BroadCom/71921/NetXtremeII/en/userdiag.htm[9/26/2012 3:29:54 PM]
Programs iSCSI configuration block 0. Used only with -fib <ib_image>.
Programs iSCSI configuration block 1. Used only with -fib <ib_image>.
Programs iSCSI configuration software. Used only with -fib <ib_image>.
Specifies the bin file to update IPMI firmware.
Specifies the bin file to update the MBA.
Programs the raw image into NVM.
Specifies the bin file to update UMP firmware.
Displays the Broadcom NetXtreme II User Diagnostics (uediag) command options.
Enables matching of VID, DID, SVID, and SSID from the image file with device IDs: Used only with
-fnvm <raw_image>.
Logs the tests results to a specified log file.
Enables/disables Multiple Boot Agent (MBA) protocol.
1 = Enable
0 = Disable
Sets the MBA boot protocol.
0 = PXE
1 = RPL
2 = BOOTP
3 = iSCSI_Boot
Enables/disables MBA VLAN.
1 = Enable
0 = Disable
Sets MBA VLAN (<65536).
Enables/disables management firmware.
1 = Enable
0 = Disable
Disables certain groups/tests.
Enables certain groups/tests.
Displays the version of Broadcom NetXtreme II User Diagnostics (uediag) and all installed adapters.
Enables/disable Magic Packet WOL.
1 = Enable
0 = Disable
Description
Verifies that registers accessible through the PCI/PCI-E interface implement the expected read-only
or read/write attributes by attempting to modify those registers.
Checks the functionality of the PCI Base Address Register (BAR) by varying the amount of memory
requested by the BAR and verifying that the BAR actually requests the correct amount of memory
(without actually mapping the BAR into system memory). Refer to PCI or PCI-E specifications for
details on the BAR and its addressing space.
Table 3.