Dell Broadcom NetXtreme Family of Adapters User Manual page 120

Broadcom Teaming Services: Broadcom NetXtreme II Network Adapter User Guide
2 Error
3 Error
4 Warning
5 Informational
6 Informational
7 Informational
8 Informational
9 Informational
10 Informational
11 Informational
12 Informational
13 Error
14 Error
15 Error
16 Informational
17 Informational
18 Error
file:///T|/htdocs/NETWORK/BroadCom/71921/NetXtremeII/en/teamsvcs.htm[9/26/2012 3:29:14 PM]
usage.
The driver cannot allocate
Failed to allocate map
map registers from the
registers.
operating system.
Failed to access
The driver cannot access PCI
configuration
configuration space registers
information. Reinstall
on the adapter.
the network driver.
The network link is
down. Check to make The adapter has lost its
sure the network connection with its link
cable is properly partner.
connected.
The network link is The adapter has established a
up. link.
The adapter has been
Network controller
manually configured for the
configured for 10Mb
selected line speed and
half-duplex link.
duplex settings.
The adapter has been
Network controller
manually configured for the
configured for 10Mb
selected line speed and
full-duplex link.
duplex settings.
The adapter has been
Network controller
manually configured for the
configured for 100Mb
selected line speed and
half-duplex link.
duplex settings.
The adapter has been
Network controller
manually configured for the
configured for 100Mb
selected line speed and
full-duplex link.
duplex settings.
The adapter has been
Network controller
manually configured for the
configured for 1Gb
selected line speed and
half-duplex link.
duplex settings.
The adapter has been
Network controller
manually configured for the
configured for 1Gb
selected line speed and
full-duplex link.
duplex settings.
The adapter has been
Network controller
manually configured for the
configured for 2.5Gb
selected line speed and
full-duplex link.
duplex settings.
The operating system does
Medium not
not support the IEEE 802.3
supported.
medium.
Unable to register the
The device driver cannot
interrupt service
install the interrupt handler.
routine.
The device driver cannot
Unable to map IO
allocate memory-mapped I/O
space.
to access driver registers.
Driver initialized The driver has successfully
successfully. loaded.
The NDIS layer has detected
NDIS is resetting the a problem sending/receiving
miniport driver. packets and is resetting the
driver to resolve the problem.
Unknown PHY
detected. Using a The driver could not read the
default PHY PHY ID.
initialization routine.
Unload other drivers that may allocate map
registers.
For add-in adapters: reseat the adapter in
the slot, move the adapter to another PCI
slot, or replace the adapter.
Check that the network cable is connected,
verify that the network cable is the right
type, and verify that the link partner (for
example, switch or hub) is working correctly.
No action is required.
No action is required.
No action is required.
No action is required.
No action is required.
No action is required.
No action is required.
No action is required.
Reboot the operating system, run a virus
check, run a disk check (chkdsk), and
reinstall the operating system.
Reboot the operating system; remove other
device drivers that may be sharing the same
IRQ.
Remove other adapters from the system,
reduce the amount of physical memory
installed, and replace the adapter.
No action is required.
Run Broadcom Advanced Control Suite
diagnostics; check that the network cable is
good.
Replace the adapter.