Dell Broadcom NetXtreme Family of Adapters User Manual page 46

NetWare Driver Software: Broadcom NetXtreme II Network Adapter User Guide
RxTicks=
Enables the use of batching receives within a specific time period.
Min = 0 (Disabled)
Max = 5000000 (5 seconds)
Units are in microseconds, The default value is 300.
TxTicks=
Enables the use of a transmit tick threshold interrupt within a specific time period.
Min = 0 (Disabled)
Max = 5000000 (5 seconds)
Units are in microseconds. The default value is 200.
TxPacketsPer=
Enables allowing an interrupt to occur after a specific amount of packets is transmitted.
Min = 0 (Disabled)
Max = 100
The default value is 20.
RxPacketsPer=
Enables allowing an interrupt to occur after a specific amount of packets is received.
Min = 0 (Disabled)
Max = 100
The default value is 75.
CheckSum=
Enables or disables the transmit and receive checksum offload feature. Checksum offload support is only for TCP/IP packets;
therefore, the default setting for checksum offload is OFF.
OFF
ON
TX
RX
FlowCtrl=
This keyword allows enabling/disabling of transmit and receive flow control.
BOTH
RX
TX
OFF
The default setting is OFF.
PDriver=
Enables the driver to operate in persistent driver mode. Use only if the adapter is placed in a hot-plug slot and only if you
must swap with an adapter that is exactly the same.
OFF
ON
file:///T|/htdocs/NETWORK/BroadCom/71921/NetXtremeII/en/netware.htm[9/26/2012 3:28:49 PM]