Error Messages - Yamaha YSP-3300 Owner's Manual

If an error message is displayed
If an error message is displayed on the TV screen, see "Error
messages" below to determine the cause and resolve the problem.
Follow the instructions below to begin measurement again.
[ERROR E-1]
Press the ENTER key to run the AUTO SETUP procedure again.
Or press the key to continue the measurement.
[ERROR E-7]
Press the key to turn this unit to the standby mode, then run
AUTO SETUP procedure again after turning this unit on.
[ERROR E-9]
1 Be sure that a wireless connection between the subwoofer and
center unit has been established (☞p. 20).
2 Press the RETURN key.
The "IntelliBeam" menu is displayed.
3 Select "BEAM+SOUND OPTIMIZE", "BEAM OPTIMIZE
ONLY", or "SOUND OPTIMIZE ONLY" and press the
1)
key.
4 Follow steps 4, 5, and 6 to measure again (☞p. 25).
[ERROR E-2] through [ERROR E-6]
1 Press the RETURN key.
The "IntelliBeam" menu is displayed.
2 Select "BEAM+SOUND OPTIMIZE", "BEAM OPTIMIZE
ONLY", or "SOUND OPTIMIZE ONLY" and press the
1)
key.
3 Follow steps 4, 5, and 6 to measure again (☞p. 25).

Error messages

ERROR E-1: Please test in quieter environment.
Cause
There is too much noise in your
listening room.
ERROR E-2: No MIC detected. Please check MIC
connection and re-try.
Cause
The IntelliBeam microphone is
disconnected.
ERROR E-3: Unexpected control is detected. Please
re-try.
Cause
Some other operations were
performed on this unit.
Remedy
Make sure that your listening
room is as quiet as possible. You
may want to choose certain hours
during the day when there is not
much noise coming from outside.
Remedy
Connect the IntelliBeam
microphone to the
INTELLIBEAM MIC jack on the
rear of this unit and begin
measurement again.
Remedy
Begin measurement again. Do
not perform any other operations
with this unit during
measurement.
ERROR E-4: Please check MIC position. MIC should
be set in front of Sound Projector. Please re-try.
Cause
The IntelliBeam microphone is
not placed in front of this unit.
ERROR E-5: Please check MIC position. MIC should
be set above 1.8m/6.0ft and re-try.
Cause
The IntelliBeam microphone is
not placed in the right distance
from this unit.
ERROR E-6: Volume level is lower than expected.
Please check MIC position/connection and re-try.
Cause
The IntelliBeam microphone
cannot collect the sound
produced by this unit.
ERROR E-7: Unexpected error happened. Please
turn off and re-try.
Cause
An internal system error
occurred.
ERROR E-9: Check the connection with subwoofer.
Cause
The subwoofer is not connected
wirelessly.
Initial settings
Remedy
Position the IntelliBeam
microphone in front of this unit
and begin measurement again.
Remedy
Position the IntelliBeam
microphone at a distance of more
than 1.8 m (6.0 ft) from this unit
and begin measurement again.
Remedy
Position the IntelliBeam
microphone properly, check the
connection, and then begin
measurement again.
Remedy
Press the key to turn this unit
to the standby mode, then run
AUTO SETUP procedure again
after turning this unit on.
Remedy
Be sure that a wireless
connection between the
subwoofer and center unit has
been established (☞p. 20) and
measure again.
27
En