Console Setup Mode - Schwinn 150 Owner's Manual

TheConsole S etupMode letsyousettheunitsofmeasurement to either E nglish o r Metric,
change themachine t ype,or seemaintenance statistics ( Error L ogandRunHours - forservice
technician useonly).
.
.
Hold down the Increase button and Decrease button together for 3 seconds while in the
Power-Up Mode to go into the Console Setup Mode.
Nete: Push STOP to go back to the previous screen or the Power-Up Mode screen.
The Console display shows the Units prompt. Push START/ENTER to start Units option. Push
the Increase/Decrease buttons to change between "Miles-Lb" (Imperial English units) and
"Km-Kg" (metric units).
Nete: If the units change when there is data in User Statistics, the statistics convert to the new
units.
3. Push START/ENTER to set.
4. The Console display shows the Machine Type prompt. Push START/ENTER to start Machine
Type option. Push the Increase/Decrease buttons to change between ELLIPTICAL and BIKE.
5. Push START/ENTER to set.
6. The Console display shows the Brightness prompt. Push START/ENTER to start the
brightness option. Push the Increase/Decrease buttons to change the brightness levels from 1
(brightest) to 5 (darkest).
7. Push START/ENTER to set.
8. The Console display shows the Error Log prompt. Push START/ENTER to start Error Log
option. The Error Log stores the last 10 errors (error type and system time of erroO, listed
newest to oldest. Push the Increase/Decrease buttons to move through the Error Log. If there
are no errors, the Console display shows "index=0".
9. Push STOP to exit.
10. The Console shows the TOTAL HOURS prompt. Push START/ENTER to see total hours for
the machine.
11. Push STOP to exit.
12. The Console display shows the Units prompt again. Push STOP to go back to the Power-Up
Mode screen.