Console Setup Mode; Results/Cool Down Mode; Pausing Or Stopping - Schwinn 140 Owner's Manual

Hide thumbs Also See for 140:
Table of Contents

Advertisement

Available languages

Available languages

3. The exercise starts at level 1. To adjust the resistance,
use the Increase/Decrease
buttons.
4. The TIME display starts to count up from 00:00.
Results
/ Cool
Down
Mode
After a workout the TIME display shows 00:00and the console shows the Workout Results. You can start your workout cool down.
The LCDdisplay shows each workout data value for 4 seconds: TIME, MILES (KM), CALORIES, C AL/HR,AVG/MPH (KMH),AVG
PWR,AV6/HR, MAX HR.The PULSEdisplay shows the current BPM value. The LEVEL display starts at 1.
If there is no RPM or PULSEsignal, the console automatically goes into Sleep Mode.
Pausing
or Stopping
1. Push the STOP/RESET button to pause your workout.
WORKOUT PAUSED mode shows on the Display.
2. Push START/ENTER to continue your workout,
or push the STOP/RESET button to stop the workout.
Console
Setup
Mode
The Console Setup Mode lets you set the units of measure to either English or Metric, adjust the contrast of the display, and
stop or start the motivational messages. Motivational messages show on the screen to increase your enthusiasm and to give
positive feedback while you are working out.
1. Hold down the LOCK/SCAN button and Increase button together for 3 seconds while in the POWER-UP
MODE to go into the CONSOLE SETUP MODE.
2. Push the Increase/Decrease
buttons to change between ELLIPTICAL and BIKE.
3. Push START/ENTER to set.
4. Push the Increase/Decrease
buttons to change between ENGLISH and METRIC units.
5. Push START/ENTER to set.
6. Push Increase/Decrease
to adjust the screen contrast (BACKLIGHTS,
"5" = maximum
intensity,
"1" =
minimum).
7. Push START/ENTER to set.
8. The Console shows TOTAL HOURS.
9. Push START/ENTER.
10. Push Increase/Decrease
to turn motivational
messages off or on.
11. Push START/ENTER to set.
12. Push Increase/Decrease
to set which software version to use ("SW30 V1.0" = x20 machine,
"SW40
V1.0" = x40 machine, or "NLS 514" = 514 machine).
13. Push START/ENTER to set.
Note:
Push STOP/RESET for previous screen.
16

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

240

Table of Contents