Table of Contents
Advertisement
STEP 1: WHAT'S
IN THE BOX?
The following
items come packed in the box:
•
VCR
•
Remote control
•
RF coaxial cable
•
AAA Batteries
STEP 2: INSTALL
BATTERIES
IN
TH E REMOTE
CONTROL
Follow these steps whenever you need to install or change the
batteries in your VCR remote.
1.
Remove the cover of the battery compartment.
2.
Place the batteries into the remote's back panel. Match the
positive (+) and negative (-) ends of each battery to the
diagram inside the battery compartment.
3.
Replace the cove_
STEP 3: CONNECT
YOUR VCR
If you connect your VCR to your home antenna or cable system
and then to your TV, use the VCR's ANT IN and RF OUT jacks for
a good signal as shown to the right.
If you have a TV with AUDIO/VIDEO jacks, use the jacks for a
better connection. Refer to the Connections section for
additional connection options.
STEP 4: PLUG IN THE VCR
Your VCR's power cord has a plastic band strung through the
blades. Remove
plastic band before
plugging
the cord into
the power
outlet.
To remove band, cut with a pair of scissors
and pull it free of the blades. Once the plastic is removed, match
the wide blade of the power cord to the wide slot in the AC
outlet. Be sure to insert the plug completely.
VCR
TV
CABLE, CABLE BOX, OR ANTENNA_
4
Advertisement
Table of Contents
