Table of Contents
Advertisement
MUTE Lowers the volume to minimum
level. Press again to restore volume.
ON.OFF Turns off a compatible
RCA, GE, ol Proscan TV.
IV
Turns on a compatible
RCA, GE, or Proscan TV and puts the remote in TV mode.
VOL +/-
Increases and decreases volume
level.
Using
the mNPUT Button
Use the INPUT button to scroll through the available Video Input Channels {LtNEI and LtNE2) and
regular broadcast signals. The Video Input Chanr_els allow you to view images from a device connected
to the DVD/VCR (like a camcorder).
1. Press the remote control'sVCR
button
to enter VCR mode. Make sure that the DVD/VCR is turned
ON.
2.
Press the remote control's
INPUT button
to tune to the Video Input Channel. LINE1 represents the
rear A/V jacks and LINE2 represents the front A/Vjacks).
3. To tune back to the broadcast signal you were previously watd'fing
through the DVD/VCR, press the
INPUT button
again.
Using the remote to Navigate through On-Screen
Menus
No matter which on-screen display you're using (the DVD
player's menu, the Info Display that appems during playback,
the VCR Main menu, or a disc's menu), you'll use the same
buttons on the remote control to move through the on-
screen display: the four arrow buttons and the OK button.
Use the alrow buttons on the remote to move through
on-
screen menus in the dhection
of the arlow button
(to go
right, press the right arrow button;
to move left, press the
left arrow button,
etc.). The arrow buttons are used to
highlight
an option. Once highlighted,
press the OK button
to select that menu option.
Usethe arrow buttons to
highlight on-screen options.
Usethe OK button to select
an option that is
highlighted.
16
Chapter 2
Advertisement
Table of Contents
