RCA CC6291 User Manual page 73

Playback on a TV Without Audio/Video Inputs (continued)
Playback Operation
1. Set the CH3/CH4 switch on the RF
output adapter to channel 3 or 4.
2. Turn on the TV, and tune it to the same
channel you selected with the RF
output adapter's CH3/CH4 switch.
3. Place adapter's VCR/TV switch in
VCR.
4. Set POWER switch to VCR. Power
indicator lights.
5. Press PLAYIPAUSE on the camcorder.
• During playback, use the playback
features described on pages 64-65.
6. Press STOP on the camcorder when
you are finished.
Seeing What the Camcorder Is Recording
1. Turn on the TV and tune it to channel
3 or 4. Turn the TV's volume down to
prevent a high-pitched squeal caused
by feedback.
2. Set the CH3/CH4 switch on the RF
output adapter to the same channel
you selected on the TV.
3. Set adapter's VCR/TV switch to VCR.
4. Set POWER switch to CAMERA.
Power indicator lights.
5. Press the thumb trigger to begin
recording. You can watch what the
camcorder is seeing (or recording)
on the TV screen.
For normal TV viewing, leave the RF
output adapter hooked up to the TV.
Disconnect the adapter's plug from the
camcorder and place the adapter's VCR/
TV switch in TE.
Note to Cable TV Installer
This reminder is provided to call your attention to Article 820-40 of the
National Electrical Code (Section 54 of Canadian Electrical Code, Part I), that
provides guidelines for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of the building as
close to the point of cable entry as practical.
71