Table of Contents
Advertisement
Playback
on a TV Without Audio/Video
Inputs
To connect your camcorder to a TV without audio/video
inputs, you need an optional
1CVA147C RF output adapter and an optional coaxial RF cable, such as VH82 or
VHg0 shown on page 74. If your TV has audio and video inputs (or is connected to a
VCR), refer to pages 68-69.
VHF Antenna
Optional
Coaxial
RF Cable
(such as VH82 or VH90)
OR
_/_
!
Back of TV
I
I
OR
]
TVConnector
Optional
_\
iI
300-75
Ohm
\
VCR/TV
Switch
Transformer
\
is _soM A_¢r
Connector
CH3/CH4
Switch
AUDIO,
RF DC
OUT, VIDEO
Jacks
RF Output
Adapter's Plug
t
Optional RF Output Adapter
(ICVA147C)
Installation
.
.
Disconnect
the VHF antenna
from
your TV.
Connect
the antenna
to the
IN FROM
ANT
connector
on the RF
output
adapter
if you are going
to
leave the adapter
connected
to the TV.
Note:
If your VHF antenna is the fiat
twin-lead
type attached by two screws,
you need an optional
300/75 ohm
transformer.
Attach one end of the optional coaxial
RF cable to the OUT TO TV
connector
on the adapter, and attach
the other end to the VHF input on
your TV as shown.
70
1
Note: If your TV has 300 ohm screw
terminals, you need a 75/300 ohm
transformer, such as VI-I54, shown on
page 74.
Attach the RF output adapter's plug to
the AUDIO, RF DC OUT, and VIDEO
jacks located under the small cover on
the back of the camcorder.
Advertisement
Table of Contents
