Table of Contents
Advertisement
Connections
Setup
Things to Consider Before You Connect
Protect
Against
Power
Surges
•
Connect all components
before you plug any of their power cords into the wall outlet,
•
Turn off the "IV and/or component
before you connect or disconnect
any cables.
•
Make sure all antennas
and cables are properly
grounded.
Refer to the Important
Safety
Instructions
on page 1.
Protect
Components
from
Overheating
•
Don't block w.'ntilation holes on any of the components.
An'ange the components
so that air
can circulate freely.
•
Don't stack components.
•
If you place components
in a stand, make sure you allow adequate
ventilation.
•
If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it
won't flow around other components.
Position
Cables Properly
to Avoid Audio
Interference
•
Insert each cable firmly into the designated
jack.
•
If you place components
above the TV, route all cables down the side of the back of the TV
instead of slraight down the middle of the TV.
•
If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep lhe twin
lead cables away from attdio/video
cables.
Important
Stand and Base Safety
Information
Choose the location t_r your "IV carefully. Place the "IV on a stand or base that is of adequate
size
and strength to prevent the "IV from being accidentally
tipped over, pushed
off, or pulled off. This
could cause personal
iniury and/or damage the "IV. Reli:r to the hnportant
Safety lnslructions
on
page 1.
Use Indirect Light
Don't place the "IV where sunlight or room lighting will be directed toward the screen. Use soft or
indirect lighting.
4
Graphics contained
within thispublication
arafiar reprex(_ntation only.
Chapter I
Advertisement
Table of Contents
