Download  Print this page

Things To Consider Before You Connect; Protect Against Power Surges; Protect Devices From Overheating; Position Cables Properly To Avoid Audio Interference - RCA R52WM24 User Manual

Rca r52wm24: users guide.
Hide thumbs


Connections & Setup

Things to Consider Before You Connect

Protect Against Power Surges

Connect all devices before you plug any of their power cords into the wall outlet.
Turn off the HD Monitor and/or device before you connect or disconnect any cables.
Make sure all antennas and cables are properly grounded. Refer to the Important Safety
Instructions on page 1.

Protect Devices from Overheating

Don't block ventilation holes on any of the devices. Arrange the devices so that air can
circulate freely.
Don't stack devices.
If you place devices in a stand, make sure you allow adequate ventilation.
If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it
won't flow around other devices.

Position Cables Properly to Avoid Audio Interference

Insert each cable firmly into the designated jack.
If you place devices above the HD Monitor, route all cables down the side of the back of the
HD Monitor instead of straight down the middle of the HD Monitor.
If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin
lead cables away from audio/video cables.

Use Indirect Light

Don't place the HD Monitor where sunlight or room lighting will be directed toward the screen.
Use soft or indirect lighting.

Cables Needed to Connect Devices to Your HD Monitor

The pictures below show the cables needed for the connections represented in this book. The
next page explains the input jacks your HD Monitor offers for connecting devices. Pages 13 and
14 give more information about your HD Monitor's input jacks and output jacks.
Component Video
S-Video cable
(Y•Pb•Pr) cables
Chapter 1


   Also See for RCA R52WM24

   Related Manuals for RCA R52WM24

Comments to this Manuals

Symbols: 0
Latest comments: