ProForm 20.0 CrossTrainer User Manual page 11

13. The Console (5) requires four 1.5V "D" batteries
(not included); alkaJine batteries are
recommended. IMPORTANT: If the eHipical
exerciser has been exposed to cold tempera-
tures, allow it to warm to room temperature
before inserting batteries into the Consoleo If
you do not do this, the console disptays or
other eJectronic components may become
damaged. Remove the battery cover and insert
four batteries into the Console. Make sure that
the batteries are oriented as shown at the right.
Then, reattach the battery cover.
Note: The Console (5) can be operated with an
optional power supply instead of batteries. To
purchase a power suppJy, call the toil-free
teJephone number on the front cover of this
manual Plug one end of the power supply into
the jack at the front of the elliptical exerciser.
Plug the other end of the power supply into an
appropriate outlet that is properly installed in
accordance with all local codes and ordinances.
14. Have a second person hold the Console (5) near
the Upright (6) as shown. Connect the console
wire harness to the Wire Harness (48).
Connect the right wire, which has a tag attached,
to the Right Controller Wire (111), which has a
tag attached. Then, connect the left wire to the
Left Controller Wire (110). insert the excess wire
downward into the Upright (6).
Attach the Console (5) to the Upright (6) with
four M4 x 16mm Self-tapping Screws (79).
13
14
5
/
Batteries
\
Battery
Cover
Console Wire Harness
79 48
"-Left Wire
ght Wire
15. Attach the Left and Right Upright Covers (10, 64)
to the Upright (6) with four M4 x 16mm
Screws (86).
15
10
86
16. Make sure that aH parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
11