8.
Position a n InnerHandlebar Cover ( 18)andan
OuterHandlebar Cover ( 19)around theLeft
Handlebar (8)asshown. T hen,pulltheLeft
Handlebar Wire(108) o utoftheLeftHandlebar
andinsert i t through the InnerHandlebar Cover.
Attach theInnerandOuterHandlebar
Covers (18,19)withthreeM4x 16mm Selfotapo
pingScrews (79)andanM4x 13mm Washer
(93). S tartall threeSelf-tapping Screwsbefore
tighteninganyof them.Avoidpinchingthe
Left Handlebar Wire (108) during this step.
Repeat this step for the Right Handlebar
and
the Right Handlebar
Wire (not shown).
Apply a generous amount of grease to the Pivot
Axle (65) and insert it into the Frame (2).
Pull the Left Controller Wire (110) through the left
Frame Cover (17), and then pull the Right
Controller Wire (111) through the right Frame
Cover.
Attach each Frame Cover (17) to the Frame (2)
with two M4 x 16mm Screws (86). Avoid pinch-
ing the Controller
Wires (110, 111) during this
step.
10. Connect the Left Handlebar Wire (108) to the
Left Controller Wire (110). Insert the excess wire
into the Left Handlebar (8).
Apply a small amount of grease to both sides of
a Wave Washer (98). Slide the Wave Washer
onto the left side of the Pivot Axle (65). Next,
slide the Left Handlebar (8) onto the Pivot Axle
as shown. Attach the Left Handlebar with an
M10 x 23mm Shoulder Screw (80) and an
M10 x 20mm x lmm Washer (81). Avoid pinch-
ing the wires during this step.
Repeat this step for the Right Handlebar
(9).