Table of Contents
Advertisement
Using
Two
VCRs
for Copying
and
Editing
Tapes
Operating
Instructions
(Refer
to hookup
on page
6.)
Use one VCR as the playback
VCR and the other
as the recording
VCR.
Caution:
The unauthorized
recording of television
programs and other
materials may infringe the
rights o{ others.
1.
2.
3.
4.
Turn on the TV and VCRs.
Tune TV to the VCR viewing
channel, either 3, 4, or "l*V's video input.
If you have connected your VCR using Option A (pag_ 6), tune recording
VCR to channel 3 or 4 - the one selected on the back of the playback VCR.
If you have connected
your VCR using Option B (page 6), display L1 in
recording
VCR's display panel to record from the AUDIO and VIDEO IN
jacks on the back of the VCR or display L2 to record from the AUDIO and
VIDEO IN jacks on the front using INPUT.
Insert the tape you want to copy into playback VCR. Insert a blank tape
with safety tab in place into recording VCR.
5.
Press PLAY, then PAUSE on playback
VCR when you reach the point on
the tape or program
where you want to begin copying.
If the tape was not
recorded
on the playback VCR, streaks may appear
and you may need to
adjust TRACKING.
6.
Press RECORD.XPR,
then PAUSE, on recording
VCR.
7.
Press PAUSE buttons
on both VCRs at the same time to begin copying the
tape.*
8.
Edit out segments
that you do not want to copy by pressing
PAUSE on
recording
VCR to stop copying the tape.
Then, locate the next segment you
want to copy on playback
VCR by using F.FWD, REW, and PLAY. Press
PAUSE on the playback
VCR. Press PAUSE at the same time on both VCRs
to resume copying.
9.
Press STOP/EJECT
on both VCRs when you are finished.
* You may turn off the TV after the recording has started as it does not have
to be on to copy a tape.
Using
Dual
Remote
with
AutoEdit
TM
Use this VCR as the recording
VCR and set it to respond
to VCR2 on the remote as described on page 9.
Use your other compatible
VCR as the playback
VCR, which should
respond
to VCR1.
1.
Follow steps 1 - 4 in the "Operating Instructions"
above.
2.
Press VCR2 on remote to control recording
VCR. Press RECORD, then
PAUSE. to put recording
VCR in pause mode.
3.
Press VGR1 on remote to control playback
VCR.
4.
Use F.FWD, REW, and PLAY to locate the point where you want to begin
copying.
Press PAUSE while VCR is playing
to put playback
VCR in pause
mode.
5.
Press EDIT on remote;
the VCRs will begin copying.
6.
Press EDIT again when you want to stop the tape from copying.
7.
Repeat steps 4 - 6 as needed.
8.
Press VCR1, STOP, then VCR2, STOP, when you are finished.
22
Advertisement
Table of Contents
