Advertisement
Can'tselect c ertain channel
Noisy stereo reception
No picture, no sound but power light
is on
• Channel may not be in Channel Memory.
Try pressing number buttons.
• If using VCR, check to make sure TV/VCR switch on VCR is in correct
position.
• To select cable channels
100 thru 128, press number button 1 until 1--
appears.
Then press other two number buttons.
CABLE/AIR
function mtist
• be in CABLE mode to select channels
higher than 69.
• Channel may be locked-out
with Parental Control feature.
May be a weak station. _Change STEREO/SAP
function to MONO setting
instead of STEREO.
Maybe someone changed
CABLE/AIR
function to wrong position.
Maybe a vacant channel is tuned.
For Channels
90, 91, and 92, make sure the component
connected
to those
INPUT jacks is turned on in order to see the picture.
If watching
VCR (connected
only through antenna input), make sure TV is
tuned to channel 3 or 4-same
as CH3/CH4
switch on VCR.
Also check to
make s.ure TV/VCR switch on. VCR is in correct position.
Sound okay, picture poor
Picture okay, sound poor
No stereo on known stereo station
Can't get two channels
in Pix-in-Pix
No picture while using Pix-in-Pix,
with S-VHS VCR or camcorder
Small picture does not have color.
• Check antenna connections.
• Try adjusting SHARPNESS
function to improve weak signals.
• Try another channel.
• Try adjusting
VOLUME,
BASS, and TREBLE controls.
• If station is sending stereo, try changing STEREO/SAP
function to MONO
setting for clearer sound.
• Try adjusting SRS (0)
controls to turn SRS (0)
off or on.
Make sure STEREO/SAP
function is in STEREO
mode.
• One channel must come thru ANTA
or B jack and the other channel must
come thru the INPUT 1 or 2 jacks.
• If using the VCR1 or VCR2 button, make sure it is programmed
to select the
proper video input channel as described
on page 26.
• If using an S-VHS component,
make sure its regular VIDEO cable is
connected
to INPUT 1 VIDEO jack on the TV.
• If using a VCR, make sure the AUDIO and VIDEO OUT jacks on the VCR
are connected
to the TV's AUDIO
and VIDEO IN jacks.
If you have an S-VHS VCR (or camcorder)
connected,
you must also
connect a cable from the VCR's VIDEO OUT jack to the TV's corresponding
VIDEO IN jack in addition
to the S-VHS cable.
The small picture will not have color if the large picture signal does not have
the color burst reference.
All color signals and some black-and-white
signals
are sent with color burst information.
Try changing channels
of the large
picture.
Remote no longer controls cable box,
VCR or audio equipment
• Try not to press any buttons on the remote while changing
its batteries.
You
may have to reprogram
the proper code into the remote.
48
continued
on next page
Advertisement
