Advertisement
Connecting
Speakers
to Back of TV
If you connect an amplifier or receiver to your TV, connect the
speakers to the amplifier/receiver instead of the TV.
Caution: Do not connect external speakers to more than one audio source at a time. You can connect a set of
speakers to either the TV or the Amplifier but not to both at the same time. If you connect the same speakers to
both the TV and the amplifier, you will damage your equipment.
If you do not connect an amplifier or receiver to your TV, you
can connect external speakers to the TV to enhance the TV's
sound.
The diagram below shows how to connect external speakers to
the speaker terminals on the back of the TV.
1..Remove the vinyl covering and twist the wire core.
2. Press and hold the lever down while inserting the wire core
into the hole. Be sure to connect (+) to (+) and (-) to (-) as
explained in the note below.
3. Release the lever.
_
Notes:
• After releasing the lever, pull gently on the wire and
check that it is connected securely to its terminal.
• Do not allow the wire core to protrude from its terminal or
contact other wires or terminals. If the cores of two wires
touch each other, damage to components could result.
Helpful Hints:
• External speakers placed next to the TV will sound better the
higher quality they are.
• Very efficient small "bookshelf" or "compact" speakers will
give good results for surround-sound use.
• Surround effect can often be improved by experimenting
with rear speaker placement.
• Surround-encoded
movies (broadcast or tape) give the best
surround effect, but regular stere,3 and mono programs will
also benefit.
Connecting
Speakers
to Back of Amplifier
or
Receiver
If you connect an Amplifier or Receiver to your TV, connect
the speakerg to the Amplifier/Receiver
instead of the TV.
Sound from the TV will then come through the
Amplifier/Receiver
and the TV's internal speakers. You can
turn off the TV's internal speaker,,; with the SPEAKERS:
ON/OFF function described on page 14.
The diagram here shows how to connect external speakers to
the speaker terminals on the back of a typical
Amplifier/Receiver.
Check the owner's manual tbr your
Amplifier/Receiver
if its speaker terminals look different than
those shown.
Back ot
The speaker switch on the back of the TV allows you to use the
external speakers two ways:
• To enhance the sound from the TV, place the speakers in the
front of the viewing area (usually beside the TV), and slide
the speaker switch to EXT. This prov|des full power to the
extemal speakers for a "fuller" sound. The internal audio
from the TV's speakers will be turned off.
SPEAKER
_o,._.,.,R._._.
I/I
I
Notes:
• After connecting speaker wire, pull it gently and check
that it is connected securely to it:_terminals.
• Do not allow the wire core to protrude from its
terminal or contact other wires or terminal. If the cores
of two wires touch each other, damage to components
could result.
• To obtain a "surround sound" effect, place the external
speakers in the rear of the viewing area, and slide the
speaker switch to INT/EXTSURR.
This provides fu!l power
to the TV's internal speakers for the front sound and a
surround signal to the rear speakers.
43
Advertisement
