Advertisement
5. Turn on TV, adjust the volume, and
• Press the TV button on the
remote to turn on the TV.
When using the remote,
Number--
remember to point it at the
'_on-
front of the TV.
• Press the VOLUME up or
down button to adjust the
volume to a desired level.
• Press the CHANNEL up or
select a channel.
TV
o°-_" _
Button
. . •
down button to select the next channel in memory. You can
also press two number buttons to select a channel. To select
a 3-digit cable channel (up to channel 128), press and hold
number button 1 until 1-- appears on the screen. Then press
the other two numbers. Channels 2-13 were programmed
into the channel memory for you at the factory, so pressing
CHANNEL up or down stops at these channels only. When
you start the Autoprogramming
feature (described in step 9),
your set will automatically scan through all channels and
place only the active channels for your area into its channel
memory.
• Details about using the remote are on page 8-12.
o
AutoProgram
the TV's channel
memory.
To start the TV autoprogramming
itself, press the MENU button
repeatedly to select SETUP MENU
and then press + to display the
uEsu
Button_
setup functions. Repeatedly press
MENU again to select the
-Button _
AUTOPROGRAM
function, and
then press +. Details are on page 22.
_°Fq
_c_
'_ + Button
::_m mm
Press MENU repeatedly to select (highlight) the CHAN MEM
function. Select the desired channel number by pressing the
CHANNEL up or down button or by pressing the two
corresponding number button:_.
Then press + to add a channel, or press - to erase a channel.
Details are on page 22.
7.
Adjust PICTURE TILT switches if necessary.
(Select models only)
Some models have an extra
large color picture tube. The
_i
HI_[_
effects of geomagnetism
(Earth's magnetic field) may
_
sr,_r.
cause the picture to tilt slightly.
The POLARITY and
STRENGTH switches on the
Pu_crv
back of the TV let you
COI_I:IEGIlON
compensate for this effect. If
the picture appears tilted, follow these steps to improve it.
• Make sure the STRENGTH switch is in the OFF position
as the diagram shows.
• Move the STRENGTH switch to the LOW position. If this
improves the tilt but it is stSll not satisfactory, move the
STRENGTH switch to the HIGH position. This should
correct the situation. If moving the STRENGTH switch
makes the tilt worso, go to the next step.
• Change the position of the POLARITY switch. If this
improves the tilt but it is sl:ill not satisfactory, move the
STRENGTH switch to the HIGH position. This should
correct the situation.
You may need to reset the POLARITY and STRENGTH
switches if the TV is moved or repositioned in the room,
especially if the TV will be tacing a different direction.
You can also add and erase channels from memory as desired.
Press MENU repeatedly to select the SETUP MENU, then
press + to display the setup functions.
3
Advertisement
