Advertisement
Thechannel memory is thelist of TV
channel numbers y ourTV will stop
on'when youpress the
CHANNEL
up
or clown button.
You can program
any list of channels
into the channel
memory.
The quickest
way to program
your
channel memory
is to use the
A UTOPROGRAM
function.
If you
use the A UTOPROGRAM
function,
your TV will automatically
cycle
through all channels
and place active
channels
into the channel memory.
Fir,;t follow the instructions
to
autoprogram
channels,
and then add
or erase individual
channels
as
desired.
1.
AutoProgramming
Channels into Channel Memory
--(with
or without remote)
1. Connect home antenna(s) or cable-
TV to your set.
.
After you have tumed on the TV
and adjusted the volume, repeatedly
press MENU to select SETUP
MENU, and then pl:ess + or - to
display the setup functions.
Repeatedly press MENU to select
the A UTOPROGRAM function.
3. Press either + or - to begin
autoprogramming.
The TV will first
program all channels for ANTA
input and then program all channels
for ANT B input (even if you only
have one: antenna input connected).
4. When the TV is finished cycling,
you can check to see which channels
are in memory by pressing the
CHANNEL Up or down button.
Notes:
• The AutoProgram feature will place into
memory active TV channels that have a
wdid signal at the time you autoprogram
your TV.
• An active channel may be missed
occasionally if its signal is very weak or if
the channel happens to be "off the air"
when the TV is autoprogrammed.
• An inactive channel may be included in the
channel memory if there happens to be
some sort of "noise" or "stray signal" on
the channel when the TV is
autoprogrammed.
• Siignals from other components connected
to the INPUT jacks can not be
autoprogrammed.
Channel 91 (which
accesses INPUT 1 jacks) was added to the
channel memory at the factory and will
remain in the channel memory until you
erase it. Channel 92 (INPUT2) and
Channel 90 (S-VIDEO connector) can be
added to channel memory if desired.
• Only channels 1-99 can be stored in
channel memory.
2.
Erasing/Adding
Channels
in Channel Memory
-- (with or without remote)
1. To erase, or add a channel,
repeatedly press MENU to select
SETUP MENU, and then press + or
- to display the setup functions.
Repeatedly press MEN.U to select
CHAN MEM function.
2. Then select the desired channel
number by pressing CHANNEL up
or down (or the two corresponding
number buttons on the remote).
3. Press + to add the channel to
memory, or press - to erase the
channell from memory.
3. Adding Video Input Channels
to Channel Memory
-- (with remote)
If you have a video device connected to
the S-VIDEO or INPUT jacks on the
back of the TV, you can view its signal
either by directly selecting channel 90
(for S-VIDEO connector), channel 91
(for INPUT I jacks), or channel 92 (for
INPUT 2 jacks) with the number buttons
on the remote or by adding those
channels to the channel memory.
Adding channels 90, 91, and 92 to
channel memory allows access to the
video inputs at the TV by pressing the
CHANNEL up and down buttons as
well as by using the remote control.
22
Advertisement
