Table of Contents
Advertisement
Installation, cont'd
Connecting the unbalanced audio output
Figure 2-5 — Unbalanced audio output connector
CAUTION
Connecting the balanced audio output
Figure 2-6 — Balanced audio output connector
SWP123 Presentation Switcher • Installation
2-6
1.
Wire a 3.8 mm, 5-pole captive screw connector as shown in figure 2-5.
Tip
See Caution
Sleeve (s)
See Caution
Tip
Connect the sleeve to ground (Gnd). Connecting the sleeve to a negative
(-) terminal will damage the audio output circuits.
Pay extra attention to the Right channel audio wiring. The "+" and "-"
layout is different from most other Extron products.
2.
Plug the 5-pole captive screw connector into the selected audio output
connector of the switcher, and plug the speaker end of the audio cable
into the powered speakers.
1.
Wire a 3.8 mm, 5-pole captive screw connector as shown in figure 2-6.
Tip
Ring
Sleeve (s)
Ring
Tip
2.
Plug the 5-pole captive screw connector into the selected audio output
connector of the switcher, and plug the speaker end of the audio cable
into the speakers.
Advertisement
Table of Contents
Need help?
Do you have a question about the SWP123 and is the answer not in the manual?
Questions and answers