Advertisement
Available languages
Available languages
1,
2.
4,
5.
Excessive
Weight
Hazard
Use two or more people
to move and install
dryer.
Failure
to do so can result
in back or other
injury.
[b protect
the floor,
use a large, flat piece of cardboard
from the dryer carton.
Place
cardboard
under the entire
back side of the dryer.
Firmly grasp the body of the dryer (not the top or console
panel).
Gently
lay the dryer on
the cardboard.
See illustration.
Examine
the leveling
legs. Find the diamond
marking.
Screw
the legs into the leg holes
by hand.
Use a wrench
to finish turning
the legs until the
diamond
marking
is no longer
visible.
Place
a carton
corner
post from dryer
packaging
under
each
of the 2 dryer
back corners.
Stand the dryer
up. Shde the dryer on the corner
posts
until it is close
to its final
location.
leave
enough
room to connect
the exhaust
vent.
1.
Using a 10,2 cm (4") clamp,
connect
vent to exhaust
outlet
in dryer. If connecting
to
existing
vent, make sure the vent is clean. The dryer vent must fit over the dryer exhaust
outlet
and inside the exhaust
hood. Check that the vent is secured to exhaust
hood with
a
10.2 cm (4") clamp.
2.
Move dryer into its final location.
Do not crush or kink vent.
3.
(On gas models)
Check that there are no kinks in the flexible
gas line,
4.
Once the exhaust
vent connection
is made, remove
the corner posts and cardboard.
Check the levelness
of the dryer. Check levelness
first side to side, then front to back.
If the dryer is not level, prop up the dryer using a wood block.
Use a wrench
to adjust the legs
up or down
and check again for levelness.
You can change your door swing from a right-side
opening
to a left-side
opening,
if desired.
E
B
C
1.
Place towel
(A) on top of dryer to protect
surface.
2.
Open dryer door. Remove bottom
screws from cabinet
side of hinges
(D). loosen
(do not
remove) top screws from cabinet
side of hinges.
3.
].ifl door until top screws in cabinet
are in large part of hinge slot. Pull door forward
off
screws. Set door (handle
side up) on top of dryer. Remove
top screws from cabinet.
Advertisement
