Advertisement
Available languages
Available languages
_,"_
_
_ _ _
_ _
"%
•
Use the Drying
Rack to dry items such as sweaters
and pillows
without
tumbling.
The drum
turns,
but the rack does not move.
[f your model does not have a drying
rack, you may be able to purchase one for your model. [b
find out whether your model allows drying
rack usage and for information
on ordering,
please
refer to the front page of the manual or contact
the dealer from whom you purchased your dryer.
NOTE: The rack must be removed
for normal
tumbling.
[_30 not use the automatic
cycle with
the drying
rack.
To use the drying rack
1.
Place drying
rack in dryer.
Style 1: Your drying
rack has front legs. Slide rear pegs into the dimples
on the back wall
of the dryer. Lower the front legs to rest on the dryer opening.
Style 2: Your drying
rack does not have front legs. Do not remove the lint screen. Slide
drying
rack over the bottom
of the dryer door opening.
Push down to secure rack on
frame.
2.
Put wet items on top of rack, leaving
space between
items. Do not allow
items to hang
over the edge of the rack. Close the door.
3.
Select a timed drying
cycle and temperature,
or an air cycle.
Items containing
foam,
rubber, or plastic
must be dried
on a clothesline
or by using an air cycle.
Refer to the
following
table.
4.
Start the dryer. Reset cycle to complete
drying,
if needed.
Rack Dry
Cycle
Temp
Time
Washable
wool items (block to shape, lay
Timed
Low
60 rain.
flat on rack)
Drying
Stuffed toys/pillows
(cotton
or polyester
Timed
].ow
60 min.
filled)
Drying
Stuffed toys/pillows
Air
N/A
90 min.
Foam rubber
filled
_no heat)
DRYER CARE
Kee l) dryer area clear and free from items that would
obstruct
the flow of combustion
and
ventilation
air.
Explosion
Hazard
Keep
flammable
materials
and vapors,
such
as
gasoline,
away
from
dryer.
Place dryer
at least
18 inches
(46 era) above
the floor
for a garage
installation.
Failure
to do so can result
in death,
explosion,
or fire.
Every load
cleaning
The lint screen is located
in the door of the dryer. Clean it before each load. A screen blocked
by lint can increase
drying
time.
To clean
I.
Pull the lint screen straight up. Roll lint off the screen with your fingers.
Do not rinse or
wash screen to remove
lint. Wet lint is hard to remove.
2.
Push the lint screen firmly
back into place.
IMPORTANT:
Do not run the dryer with
the lint screen loose, damaged,
blocked,
or missing.
Doing
so
can cause overheating
and damage
to both the dryer and fabrics.
If lint falls off the screen into the dryer during
removal,
check the exhaust
hood and
remove the lint. See "Checking
Your Vent."
18
Advertisement
