Maytag MER6875BCW17 Use And Care Manual page 9

Control Panel
AB C D
Lower
Oven
F
< vLe°n%,
m 0 P O
The control panel is designed for ease in programming. The displaywindow on the control shows time of day, timer and oven functions.
Control panel shown includes model specific features. (Styling may vary depending on model.)
iiiiiiiiiii_i!ii!ii!ii!i_
iiiiiiiiiil
iiiiiiiiiil
iiiiiiiiiii
iiiiiiiiiil
Bake
Broil
Clean
Keep Warm
Toast
Number Pads
CANCEL
Convect Bake
Convect Roast
Timer 1 or 2
Clock
Cook & Hold
Delay
Oven Light
Favorite
Autoset
Surface
Warming Center
Use for baking and roasting.
Use for broiling and top browning.
Use to set self-clean cycle.
Use to keep cooked food warm in oven.
Use for toasting bread and products
toasted in toaster or toaster oven.
Use to set time and temperature.
Cancels all operations except timer,
clock and Surface Warming Center.
Use for convection baking.
Use for convection roasting.
Sets the timer.
Use to set time-of-day clock.
Bakes for a preset time, then keeps
food warm for 1 hour.
Programs the oven to start baking or
cleaning at a later time.
Use to turn the oven lights on or off.
Use to set and save a specific Cook &
Hold procedure.
Use to quickly set temperatures.
Use to keep foods warm on the cooktop
for serving.
Using the Touchpads
. Press the desired pad.
. Press the number pads to enter time or temperature.
. Or, press the Autoset pad to enter temperature.
. A beep will sound when any pad is touched.
. A double beep will sound if a programming error occurs.
Important: Four seconds after entering the time or
temperature it will automatically be entered. If more than 30
seconds elapse between touching a function pad and the
number pads, the function will be canceled and the display
will return to the previous display.
Clock
The clock can be set to display time in a 12-hour or 24-hour
format. The clock is set at the factory for the 12-hour format.
To change the clock to 24=hour format:
1. Press and hold the upper CANCEL pad and
Favorite pad for three seconds.
12 Hr flashes in the display.
2. Press the Autoset pad to select 24 Hr; press
again to select 12 Hr. ". ,
.
Set the time of day following the directions in
the Toset the Clock section.
To set the Clock:
1. Press the Clock pad.
. The time of day flashes in the display.
. Colon flashes in the display.
2. Press the appropriate number pads to set the time of day.
3. Press the Clock pad again or wait four seconds.
. The colon will remain on.
When electrical power is supplied or after a power
interruption, the last clock time before power was interrupted
will flash.
To recall the time of day when another time function is
showing, press the Clock pad.
8