Dispenser - LG LSC27990TT Service Manual

HOW TO DISASSEMBLE AND ASSEMBLE
6. DISPENSER
1) Disconnect funnel and button assembly by pulling down
and forward.
4) Loosen four screws with a phillips screwdriver and pull
the funnel assembly to disconnect.
Button
Funnel Assembly
j/L .
I
Funnel
Assembly
2) Remove display frame assembly by making a gap
between a display frame assembly and door with a flat
blade screwdriver and pulling it forward. The cover
dispenser is attached with a hook.
3) The display assembly can be connected by pressing the
top of the dispenser cover and pushing it after
separating the display frame from its housing.
5) The duct cap assembly can be disconnected if the hold
lever connecting screw is loosened with a phillips driver.
Solenoid Assembly
• , Holder
• , Lever
a i
Duct Cap
Assembly
6) To install the duct cap assembly, insert one end of the
spring into the right hole of the dispenser lever and
insert the other end into the right hole in the top part of
the dispenser. Then attach the holder at the solenoid
switch.
Sheath Heater
/
Solenoid Assem_[bly __ "'
Spring
_ Dispenser Lever
- 97 -