LG GR-L247ER Parts List And Instructions Manual page 8

HOW TO INSTALL REFRIGERATOR
3. How to Control the Amount of'Water Supplied to Icemaker.
3-1. Confirm the amount of water supplied to the icemaker.
1. Pull out the ice bank in the upper part of the freezer compartment.
Caution : • Do not put hands or tools into the chute to confirm
the operation of geared motor.
it may damage refrigerator or hurt hands.)
• Check the operation of motor with its operation
noise.
2. Apply electricity after connecting water pipe.
1) Press test switch under the icemaker for two seconds as shown below.
2) The bell tings(ding-dong) and ice tray rotates and water comes out from the icemaker water tube,
3) The water shall be supplied two or three times into the tray, The amount of water supplied for each time is small.
Put a water container under the ice tray and press test switch.
4) When ice tray rotates, the water in it will spill. Collect the spilt water and throw away into the sink.
5) When ice tray has finished rotation, water comes out fTom the water tube. Confirm the amounts of water in the ice tray.
(refer to fig. The opSmum amount of water is 110cc)
Confirm the amount
of water
Test Switch
Ice maker
* It [s acceptable if the adjusted level of water is a bit smaller than optimum level.
- 23 -