LG GR-L247ER Parts List And Instructions Manual page 7

HOW TO INSTALL REFRIGERATOR
• Install Water Fitter (Applicable to some models only)
• Before Installing water filter
1. Before installing the filter, take out the top shelf of the
refrigerator after tilting it to the direction (O) and lifting it
to the direction (_)) and move it to the lower part.
2, Remove the lamp cover by pressing the protrusion
under the cover and pulling the cover to the front.
Control box
and the fastening indication line
-Controlbox
• Installing water filter
1. Initial installation of water filter
Remove the filler substitute cap by turning it
counterclockwise ((_) by 90 degrees end pulling it down.
Note : Keep it safe to use it later when you do not use the
filte_
Remove the red cap from the filler and attach the
sticker, Insert the upper part of the filter (O) after
aligning with the guideline marked on the control box,
and fasten it by turning it clockwise by 90 degrees.
Note : Check that the guideline and the fastening
indication line ere aligned.
J ubstitute
cap
°n ---.
2. Replacement of water filter
While holding the lower part of the filter, turn it
counterclockwise ((_) by 90 degrees and pull II down.
Note : Check that the guideline end the loosening
indication line are aligned.
ningwith the guide line
the loosening indicationline
• After installing water filter
Reassemble the lamp cover and the top shelf of the
refi'EJeretor.To place the top shelf of the refrigerator, raise
the front part of the shelf a bit so that the hook of the shelf
is fit into the groove.
In order to clean the water filter system, drain water for
about 3 min.
Note : Then open the door of the refrigerator and check for
water droppings on the shelf under the tilter.
- 22 -